L S 3 9 3    
  UPLIGHT LUMINAIRE _( I P 6 8 )
     
     


i n g r o u n d

 




The In-ground Stainless Steel Range incorporates quality and innovation in materials, manufacture and finishes: from robotic fusion welded marine grade 316 stainless steel housings through to the IP68 rating achieved by its dynamic, high temperature silicone cover seal with memory additives.
 
 
Source

12volt, MR16 (35watt IRC max)
Remote transformer only, sold separately – consult factory for details

 
Features
Ingress protection rating - IP689
Suitable for wet locations
OptiClear™ max static load - 8300lb (3750kg)
Applied to a 2in (51mm) diameter area in the center of the glass
Corrosion resistant 316 stainless steel - marine grade
Modular design, adjustable gimbal for easy installation and maintenance
Adjustable lamp angle to 20º
Non-galling clinch nuts dramatically reduce cross threading or binding
Self resetting thermal protection device to protect unit from overheating
Corrosion resistant stainless steel cover fasteners
Internal honeycomb louver
 
Options
HumanTouch™ total temperature reduction technology
OptiClear™ lens for increased efficiency
High optical transmission, toughened
GripGlass™ slip resistant safety glass
Recessed, round flush and square flush covers
Installation
- Direct burial
- Mounting collar (decks and grates)
- Pre-installation (concrete and drive-over)
 
 
 

Accessories
LS648 Brass grill
LLLS Linear spreader lens  
LS633 Dichroic filters  
LS643 Dichroic filters


 

Installation: Direct Burial
 
Recessed Cover
For concrete or similar surface, where no lid overhang is desired.
Brass: Polished
Stainless steel 316: Polished
Stainless steel 316: Brushed
(Note: Not suitable for drive over)
 
Flush Cover Plate
For surfaces where the lid has to cover a gap between fitting and surround.
Brass: Polished
Stainless steel 316: Polished
Stainless steel 316: Brushed
(Note: Not suitable for drive over)
 


 

Installation: Pre-Installation Kits
 
Pre-Installation - Decks & Grates
(Add LS647 accessory to the specification for this configuration.)
For hollow floors.
Brass: Polished
Brass: Brushed
Stainless steel 316: Polished
Stainless steel 316: Brushed
 
Pre-Installation - Concrete (Block Out)
(Add LS647-K accessory to the specification for this configuration.)
For drive over. For installation in to concrete or similar surface and for when it may be preferable to install mounting location and cable before installing lamp fixture.
Brass: Polished
Brass: Brushed
Stainless steel 316: Polished
Stainless steel 316: Brushed
 


 

Adjustable Gimbal

 





 

Literature available

DXF files available


Contact Lumascape
Copyright 2004 Lumsacape USA Inc.
Return to www.lumascape.com home